Back to Contents Page
Stand: Dell™ OptiPlex™ GX150 System User's Guide
To remove the stand from the small form-factor and small desktop
computers, perform the following steps:
- Turn the computer over so that the stand is at the top.
- Loosen the thumb screw and lift the stand away (see the following
figures).
- Place the computer in a horizontal position.
Small Form-Factor Computer Stand
 |
| 1 |
Locator hole |
| 2 |
Thumb screw |
|
Small Desktop Computer Stand
 |
| 1 |
Locator hole |
| 2 |
Thumb screw |
|
To attach the stand to the small form-factor and small desktop
computers, perform the following steps:
- Place the computer on its right side so that the drive bays are at
the bottom.
- Fit the stand onto what was the left side of the computer.
- Position the stand as shown in the figure by aligning the large round
hole in the stand with the securing button on the side of the cover and aligning the
captive screw in the stand with the screw hole in the cover.
- When the stand is in place, tighten the thumbscrew.
- Rotate the computer so that the stand is at the bottom and the drives
are at the top.
Back to Contents Page
